Status: app version v26.11.250.0

Contour lines

Contour lines are computed from the terrain model (DEM) — without a DEM the section stays hidden in the DEM panel. The lines sit on round world elevations (multiples of the interval) and can be exported as DXF.

Action Effect
“Generate/Update”Computes the contour lines from the current DEM and shows them in the viewport. The status line reports the number of lines, how many were filtered out as too short and — with smoothing on — the maximum deviation from the unsmoothed course. “Remove” hides them again. The lines appear strip by strip (unsmoothed at first); if the chosen interval would produce too many line pieces, nothing is computed and the message names the smallest interval that fits.
Interval, index interval, minimum length, label spacingElevation spacing of the lines, spacing of the boldly drawn index lines, cut-off for short slivers and spacing of the labels along a line — all four in the configured unit (m/ft/US ft).
Labels and smoothingLabels either on the index lines only, on all lines, or off. Smoothing (two Chaikin passes, off by default) rounds off the staircase course; the reported deviation says how far the line moved away from the raster course. Leave it off for exports used in calculations (ⓘ next to smoothing).
“Bridge gaps”By default the lines run continuously even across areas where the DEM interpolated holes. Switched off they deliberately break there — making it visible where real measured data is missing.
"Limit to boundary"Only visible while a surface is marked as boundary. When generating, the lines end at the boundary — the DEM itself stays unchanged, so one DEM serves any number of cut-outs. The limit is node-accurate (one raster cell), not exact at the polygon edge. The lines are a snapshot: regenerate after changing or moving the boundary. DXF and point export contain exactly the lines shown. If the DEM's source slot carries an open shift, the limited run is refused.
Colour and colour range“Elevation ramp” applies the DEM elevation ramp (blue → teal → yellow → red) to the lines. The two-handle slider below the spectrum bar stretches the ramp over a freely chosen elevation window; recolouring is immediate, with no recomputation. “Full range” resets it. The colours are display only — the DXF export stays layer-coloured.
“Export”Writes the displayed contour lines in the chosen export format: as DXF with 2D polylines and an elevation attribute (compact) or with true 3D polylines, optionally with additional 3D points at all vertices. Normal lines, index lines, labels and points are placed on separate layers. For volume calculations in CAD, three formats write only the 3D points: “3D points only (DXF)” (POINT objects on one layer, without lines and labels), XYZ file (“x y z” per line) and CSV file (header X,Y,Z), each rounded to millimetres. If smoothing is on, the points come from the smoothed lines and no longer sit exactly at their height (see ⓘ next to smoothing).

Work with your own point cloud.

Open point clouds, trace existing features and export geometry for CAD — directly in your browser, with point cloud data processed locally.

Try free for 14 daysRequest a demo