Status: app version v26.11.250.0
Creating a slope
The slope generator puts a slope with two inclinations (cut and fill) around a formation level and intersects it with the terrain. The result is lines on a layer and, if wanted, a volume A/B.
| Topic | Effect |
|---|---|
| Workflow | On the card of a formation level (area or volume) choose “Slope…”. The dialog computes a preview: the daylight line where the slope meets the terrain, and connectors from the formation level edge to that line. “Apply” creates the shapes (one undo step). While the dialog is open you can keep rotating and zooming the view. Locked areas from DXF/GeoJSON are allowed as a formation level; its geometry is not changed. |
| Fields | Terrain: point cloud (slot) or DEM; for clouds “Ground only” and “mean / lowest point per cell”. Slope for cut and for fill as 1 : n (n metres horizontal per metre of height, 0.1 to 20; preset 1.5 and 2, the last values are remembered). Resolution: empty = automatic (the value is shown as placeholder). Target layer: a new layer “Slope …” or an existing one. “Create volume A/B” is preselected (when regenerating, the checkbox follows the existing volume). |
| Formation level height | “Level at height” puts the whole formation level on one height in the height system of the data. “Heights of the shape” uses the heights of its points; the interior is interpolated from them. “Level” is preselected when the edge is on average less than 5 cm off the terrain. |
| What is created | On the target layer: a copy of the formation level edge at design height, the daylight line (with terrain heights), one line per untouched island in the terrain, and the connectors as short lines. With the checkbox also a volume A/B: reference is the terrain, comparison a TIN built from the shapes on the target layer. Foreign shapes on that layer enter the TIN; the status line says so. The volume knows no holes: it computes across islands and deviates there (the dialog says so). |
| Regenerate | If a formation level already has a slope, its card shows “Regenerate slope”. The dialog opens with the remembered values and says how many shapes will be replaced: all previous slope shapes are deleted and created anew – manual edits to them are lost. Converted slope shapes are replaced as well. An existing volume A/B is always updated to the new line, even without the checkbox; if it is locked, nothing happens. Everything together is one undo step. |
| Snapshot | The slope is a snapshot. If the formation level, terrain or cloud change afterwards, the shapes do not follow; only “Regenerate slope” recomputes. Deleting the formation level leaves the slope shapes in place. |
| Estimate | Cut, fill and slope area in the dialog are an estimate from the same grid. The number of the volume shape is authoritative. In the test cases the estimate was off by 0.01 % to 3 %, most for small quantities with mixed cut and fill. |
| When nothing is created | The dialog names the reason and creates nothing: the terrain ends before the slope reaches it (the line would stay open); the formation level lies at terrain height; no terrain at the formation level; the slope is too large to compute (a coarser resolution, a steeper slope or a different height helps); the computation failed; the terrain slot has an unconfirmed shift or alignment; a shape is being edited or another dialog is open; a locked slope shape or the locked volume A/B would be replaced. |
| Limits | The line is only as accurate as the resolution; on rough or stepped terrain it can be off by up to one cell. There are no berms and no separate slope per edge. Shallow bends below 15° get no connector of their own. The computation runs in the main thread; large formation levels at very fine resolution and many edge points in “Heights of the shape” mode can take noticeable time. A height conversion of the project carries the design height of the formation level with it. |
Work with your own point cloud.
Open point clouds, trace existing features and export geometry for CAD — directly in your browser, with point cloud data processed locally.
Try free for 14 daysRequest a demo